Viewing file: 
gpio.h (7.98 KB) -rw-r--r--Select action/file-type:
(
+) |
(
+) |
(
+) |
Code (
+) |
Session (
+) |
(
+) |
SDB (
+) |
(
+) |
(
+) |
(
+) |
(
+) |
(
+) |
#ifndef _ASM_GENERIC_GPIO_H
#define _ASM_GENERIC_GPIO_H
#include <linux/kernel.h>
#include <linux/types.h>
#include <linux/errno.h>
#ifdef CONFIG_GPIOLIB
#include <linux/compiler.h>
/* Platforms may implement their GPIO interface with library code,
* at a small performance cost for non-inlined operations and some
* extra memory (for code and for per-GPIO table entries).
*
* While the GPIO programming interface defines valid GPIO numbers
* to be in the range 0..MAX_INT, this library restricts them to the
* smaller range 0..ARCH_NR_GPIOS-1.
*
* ARCH_NR_GPIOS is somewhat arbitrary; it usually reflects the sum of
* builtin/SoC GPIOs plus a number of GPIOs on expanders; the latter is
* actually an estimate of a board-specific value.
*/
#ifndef ARCH_NR_GPIOS
#define ARCH_NR_GPIOS 256
#endif
/*
* "valid" GPIO numbers are nonnegative and may be passed to
* setup routines like gpio_request(). only some valid numbers
* can successfully be requested and used.
*
* Invalid GPIO numbers are useful for indicating no-such-GPIO in
* platform data and other tables.
*/
static inline bool gpio_is_valid(int number)
{
return number >= 0 && number < ARCH_NR_GPIOS;
}
struct device;
struct seq_file;
struct module;
struct device_node;
/**
* struct gpio_chip - abstract a GPIO controller
* @label: for diagnostics
* @dev: optional device providing the GPIOs
* @owner: helps prevent removal of modules exporting active GPIOs
* @request: optional hook for chip-specific activation, such as
* enabling module power and clock; may sleep
* @free: optional hook for chip-specific deactivation, such as
* disabling module power and clock; may sleep
* @direction_input: configures signal "offset" as input, or returns error
* @get: returns value for signal "offset"; for output signals this
* returns either the value actually sensed, or zero
* @direction_output: configures signal "offset" as output, or returns error
* @set: assigns output value for signal "offset"
* @to_irq: optional hook supporting non-static gpio_to_irq() mappings;
* implementation may not sleep
* @dbg_show: optional routine to show contents in debugfs; default code
* will be used when this is omitted, but custom code can show extra
* state (such as pullup/pulldown configuration).
* @base: identifies the first GPIO number handled by this chip; or, if
* negative during registration, requests dynamic ID allocation.
* @ngpio: the number of GPIOs handled by this controller; the last GPIO
* handled is (base + ngpio - 1).
* @can_sleep: flag must be set iff get()/set() methods sleep, as they
* must while accessing GPIO expander chips over I2C or SPI
* @names: if set, must be an array of strings to use as alternative
* names for the GPIOs in this chip. Any entry in the array
* may be NULL if there is no alias for the GPIO, however the
* array must be @ngpio entries long. A name can include a single printk
* format specifier for an unsigned int. It is substituted by the actual
* number of the gpio.
*
* A gpio_chip can help platforms abstract various sources of GPIOs so
* they can all be accessed through a common programing interface.
* Example sources would be SOC controllers, FPGAs, multifunction
* chips, dedicated GPIO expanders, and so on.
*
* Each chip controls a number of signals, identified in method calls
* by "offset" values in the range 0..(@ngpio - 1). When those signals
* are referenced through calls like gpio_get_value(gpio), the offset
* is calculated by subtracting @base from the gpio number.
*/
struct gpio_chip {
const char *label;
struct device *dev;
struct module *owner;
int (*request)(struct gpio_chip *chip,
unsigned offset);
void (*free)(struct gpio_chip *chip,
unsigned offset);
int (*direction_input)(struct gpio_chip *chip,
unsigned offset);
int (*get)(struct gpio_chip *chip,
unsigned offset);
int (*direction_output)(struct gpio_chip *chip,
unsigned offset, int value);
int (*set_debounce)(struct gpio_chip *chip,
unsigned offset, unsigned debounce);
void (*set)(struct gpio_chip *chip,
unsigned offset, int value);
int (*to_irq)(struct gpio_chip *chip,
unsigned offset);
void (*dbg_show)(struct seq_file *s,
struct gpio_chip *chip);
int base;
u16 ngpio;
const char *const *names;
unsigned can_sleep:1;
unsigned exported:1;
#if defined(CONFIG_OF_GPIO)
/*
* If CONFIG_OF is enabled, then all GPIO controllers described in the
* device tree automatically may have an OF translation
*/
struct device_node *of_node;
int of_gpio_n_cells;
int (*of_xlate)(struct gpio_chip *gc, struct device_node *np,
const void *gpio_spec, u32 *flags);
#endif
};
extern const char *gpiochip_is_requested(struct gpio_chip *chip,
unsigned offset);
extern int __must_check gpiochip_reserve(int start, int ngpio);
/* add/remove chips */
extern int gpiochip_add(struct gpio_chip *chip);
extern int __must_check gpiochip_remove(struct gpio_chip *chip);
extern struct gpio_chip *gpiochip_find(void *data,
int (*match)(struct gpio_chip *chip,
void *data));
/* Always use the library code for GPIO management calls,
* or when sleeping may be involved.
*/
extern int gpio_request(unsigned gpio, const char *label);
extern void gpio_free(unsigned gpio);
extern int gpio_direction_input(unsigned gpio);
extern int gpio_direction_output(unsigned gpio, int value);
extern int gpio_set_debounce(unsigned gpio, unsigned debounce);
extern int gpio_get_value_cansleep(unsigned gpio);
extern void gpio_set_value_cansleep(unsigned gpio, int value);
/* A platform's <asm/gpio.h> code may want to inline the I/O calls when
* the GPIO is constant and refers to some always-present controller,
* giving direct access to chip registers and tight bitbanging loops.
*/
extern int __gpio_get_value(unsigned gpio);
extern void __gpio_set_value(unsigned gpio, int value);
extern int __gpio_cansleep(unsigned gpio);
extern int __gpio_to_irq(unsigned gpio);
/**
* struct gpio - a structure describing a GPIO with configuration
* @gpio: the GPIO number
* @flags: GPIO configuration as specified by GPIOF_*
* @label: a literal description string of this GPIO
*/
struct gpio {
unsigned gpio;
unsigned long flags;
const char *label;
};
extern int gpio_request_one(unsigned gpio, unsigned long flags, const char *label);
extern int gpio_request_array(const struct gpio *array, size_t num);
extern void gpio_free_array(const struct gpio *array, size_t num);
#ifdef CONFIG_GPIO_SYSFS
/*
* A sysfs interface can be exported by individual drivers if they want,
* but more typically is configured entirely from userspace.
*/
extern int gpio_export(unsigned gpio, bool direction_may_change);
extern int gpio_export_link(struct device *dev, const char *name,
unsigned gpio);
extern int gpio_sysfs_set_active_low(unsigned gpio, int value);
extern void gpio_unexport(unsigned gpio);
#endif /* CONFIG_GPIO_SYSFS */
#else /* !CONFIG_GPIOLIB */
static inline bool gpio_is_valid(int number)
{
/* only non-negative numbers are valid */
return number >= 0;
}
/* platforms that don't directly support access to GPIOs through I2C, SPI,
* or other blocking infrastructure can use these wrappers.
*/
static inline int gpio_cansleep(unsigned gpio)
{
return 0;
}
static inline int gpio_get_value_cansleep(unsigned gpio)
{
might_sleep();
return gpio_get_value(gpio);
}
static inline void gpio_set_value_cansleep(unsigned gpio, int value)
{
might_sleep();
gpio_set_value(gpio, value);
}
#endif /* !CONFIG_GPIOLIB */
#ifndef CONFIG_GPIO_SYSFS
struct device;
/* sysfs support is only available with gpiolib, where it's optional */
static inline int gpio_export(unsigned gpio, bool direction_may_change)
{
return -ENOSYS;
}
static inline int gpio_export_link(struct device *dev, const char *name,
unsigned gpio)
{
return -ENOSYS;
}
static inline int gpio_sysfs_set_active_low(unsigned gpio, int value)
{
return -ENOSYS;
}
static inline void gpio_unexport(unsigned gpio)
{
}
#endif /* CONFIG_GPIO_SYSFS */
#endif /* _ASM_GENERIC_GPIO_H */
